Practice Step 2 – Take Upper Teeth impression
Please read all of the illustrated instructions and watch the video prior to taking your teeth impression.
Teeth Flippers step-3
1. Take 1 purple putty and 1 white putty from the supplied container. The putty should not be warmer than room temperature, so be sure it is not before mixing.
2. Mix the 1 purple putty and the 1 white putty together with your fingers until it becomes a solid purple. This should be completed in no more than 40 seconds.
3. When the putty becomes a solid purple with no more white showing, then stop mixing. Do not continue to mix once it is a solid purple or the putty will harden too fast.
4. Take the ball of mixed putty and place it into the tray.
5. Use your thumbs to spread the putty evenly throughout the entire tray.
6. The putty should fill the entire tray from edge to edge.
7. Insert the putty filled tray and center it over your teeth.
8. Use both thumbs to push evenly straight up on the tray until your teeth almost hit the bottom of the tray. The most common mistake is that the teeth are not deep enough in the putty.
9. Keep the impression tray and putty on over your teeth for 5 full minutes so that the putty can fully harden. If you remove the tray before the full 5 minutes, the impression will be distorted and your completed teeth device will not fit properly.
10. After the 5 minutes is up, first push up on the handle of the tray to break the suction and then you will pull the tray down off of your teeth by using the plastic stem as shown.
Notice how the teeth are centered and not too close to the edges of the tray.
Notice how the teeth are deep in the putty and almost touching the bottom of the tray.